Installation of eTile panels

A. Preparation for assembly

Before you start assembling the eTile panels, make sure that you have a prepared roof structure. På denne stasjonen, du skal du already-installerer med en pitch 240 mm, kabeldrøs lagt og en return kabel routeret. Bînin bîra xwe ku hemî girêdanên elektrîkê ji hêla elektrîkê ve têne çêkirin - hûn bala xwe didin sazkirina banê.

B. The order of assembly

We always mount from right to left, in vertical rows. We start the first row from the top of the roof. At each stage, check the level and vertical of the mounted elements - this is crucial for the aesthetics of the entire roof.

Start by installing the runway near the hood, leaving 5 mm of clearance for proper water drainage. Er du första ett Half-panel till battens med skruv i mellanen del ramme.

C. Combining successive modules

Cada moduulo successiva a subida a un fastener installato a la parte superior del panel anterior. A gap between the glasses should be exactly 20 mm - this is important for the correct operation of the system.

You perform the assembly in three steps:

1. Inserting the panel under the fastener

2. latching the side lock

3. bolting to the patches

D. Checkpoints

At each stage of assembly, check:

· Whether a 20 mm gap between the glasses is maintained

· Whether the panels are leveled

· Whether the side locks are properly latched

· Whether the screws are placed in the middle part of the frame

Bînin bîra! It is forbidden to walk on glass panels - you can scratch or damage them. Use only designated communication strings.

E. Completion of assembly

After installing all the panels, the electrician will connect the last panel to the return cable and bring the wires to the inverter. La tua tasca è di controllare tutte le blocchi e connessioni prima di seguire dalla banzo.

‍